ISO 104-2015 pdf free download

ISO 104-2015 pdf free download.Rolling bearings — Thrust bearings — Boundary dimensions, general plan
Roulements — Butées — Dimensions d’encombrernent, plan général.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
Iso 582, Rolling bearings — Chamfer dimensions — Maximum values
ISO 5593. Rolling bearings — Vocabulary
ISO 15241, Rolling bearings — Symbols for physical quant ities
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 5593 and the following apply
3.1
single-direction thrust bearing with flat back faces
thrust rolling bearing with flat back faces intended to support axial load in one direction only
3.2
double-direction thrust bearing with flat back faces
thrust rolling bearing with flat back faces intended to support axial load In both directions
3.3
central shaft washer
central washer which is intended to be mounted on a shaft
[SOURCE: ISO 20516:2007, 3.51
4 Symbols
For the purposes of this International Standard, the symbols given in ISO 15241 and the following apply.
The symbols shown in Eiguresl and 2 and the values given in Tables 1 to 9 denote nominal dimensions,
unless specified otherwise.
B height of central shaft washer
D outside diameter of housing washer
D1 bore diameter of housing washer
D15 mm smallest single bore diameter of housing washer
d bore diameter of shaft washer, single-direction thrust bearing with flat back faces
d1 outside diameter of shaft washer, single-direction thrust bearing with flat back faces
dismax largest single outside diameter of shaft washer
d2 bore diameter of central shaft washer, double-direction thrust bearing with flat back faces
d3 outside diameter of central shaft washer, double-direction thrust bearing with flat back faces
d35 max largest single outside diameter o central shaft washer
r back face chamfer dimension of shaft washer and housing washer
r5 mm smallest single back face chamfer dimension of shaft washer and housing washer face chamfer dimension of central shalt washer
rls men smallest single face chamfer dimension of central shaft washer
T bearing height. single-direction thrust bearing with flat back faces
T1 bearing height, double-direction thrust bearing with flat back faces.ISO 104-2015 pdf free download.