Position:Home>ISO Standards>ISO 730-2009 pdf free download

ISO 730-2009 pdf free download

ISO 730-2009 pdf free download.Agricultural wheeled tractors — Rear-mounted three-point linkage — Categories IN, I, 2N, 2, 3N, 3, 4N and 4
Tracteurs agricoles a roues — Attelage trois points monte a I’amère — Categories IN, 1, 2N, 2, 3N, 3, 4N et 4.
lower hitch point height
height of the centre of the lower hitch points above the ground level when they are fully lowered using the full extent of manual adjustment provided in the lift rods In conjunction with the movement range, and when the lower hitch point axis is maintained horizontal to the ground in a transverse plane
3.2.15
levelling adjustment
movement allowing inclination of the implement, measured vertically and with one lower link horizontal, so that either lower hitch point can be moved higher or lower than the other
3.2.16
lower hitch point span
distance between the shoulders of the lower hitch pins, against which the sides of the lower link ball joints abut
3.2.17
llnchpln hole distance
distance from the centreline of the linchpin hole to the shoulder of the hitch pin
3.2.18
movement range
vertical movement of the lower hitch points corresponding to the power travel of the lift, excluding any adjustment in the lift rod linkage
3.2.19
transport height
total height of the lower hitch points above the ground using the full extent of manual adjustment provided in the lift rods in conjunction with the movement range, with the lower hitch point axis maintained horizontal to the ground in a transverse plane
3.2.20
lower hitch point clearance
clearance, expressed as a radial dimension, from the lower hitch point axis to the outside diameter of the lyre, mudguard or other part of the tractor, measured in a longitudinal vertical plane with the implement raised to transport height and all side-sway prevented
3.2.21
pitch
angle of the mast to the vertical, considered positive when viewed anticlockwise from the left-hand side of the tractor
3.2.22
mast adjustment
usable range of pitch of the mast from a vertical plane, measured at the maximum and minimum heights of the lower hitch points above the ground between which the mast, at the specified mast height.ISO 730-2009 pdf free download.

Download Information
Go To Download

All resources on this website are from the Internet. It is only for personal study and research. No one is allowed to use it for any commercial purpose. If you need, please buy the genuine standard. If there is any infringement of your copyright, please contact the webmaster in time, and I will correct it immediately.