ISO 11529-2013 pdf free download

ISO 11529-2013 pdf free download.Milling cutters — Designation — Shank-type and bore-type milling cutters of solid or tipped design or with indexable cutting edges
Fraises — Designation — Fraises deux tallies, a queue monobioc ou a lames oufraises a alésage a plaquettes amovibles.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3002-1, Basic quantities in cutting and grinding — Part 1: Geometry of the active part of cutting tools — General terms, reference systems, tool and working angles, chip breakers
ISO 3002-3, Basic quantities in cutting and grinding — Part 3: Geometric and kinematic quantities in cutting
3 Summary explanation of the designation system
Shank-type and bore-type milling cutters are designated by codes comprising symbols which identify the important features of the mills.
Extensions to the designation codes to include manufacturer’s or supplier’s information about the milling cutters are described in Clause 5.
No addition to or extension of the designation system given in this International Standard shall be made without consultation with ISO/TC 29 and without its agreement. The designation code shall consist of the following:
4.5 Symbol identifying the cutting-edge angle, Kr
The number symbol identifying the cutting edge angle is a three-digit number corresponding to the nominal cutting edge angle, in degrees, and omitting any decimals. ac- is defined for the various types of end mill in 4L and in Iso 3002-1, 5.1.1.1.
The three-digit number designates also milling cutters of dove tail” design, where the cutting edge
angle is larger than 90°.
EXAMPLE 1 Cutting edge angle 90°: symbol “090.
EXAMPLE 2 Dove tail milling cutter with cutting edge angle l20: symbol 120.
For end mills of types K and N (see 4Z). the symbol identifying the cutting edge angle shall be replaced by 000 Itriple (or treble) zeroj.
If end mills and milling cutters are assembled with cartridges that are carrying the cutting edges, the cutting edge angle shall be replaced by OCA (zero, upper case letter C, upper case letter A).
If Kr IS a decimal value, the symbol identifying the cutting edge angle shall be replaced by XXX, and the actual value shown as the manufacturer’s information (see Clause S).
4.6 Symbol identifying the design of end mill or milling cutter
The symbol 6 defines either the design of the end mill or milling cutter, if it is of solid or tipped design, or the design of how the replaceable cutting edges are fixed on to the tool body.
For end mills or milling cutters of solid or tipped design, the letter symbol shall be as shown in Table 3:ISO 11529-2013 pdf free download.