Position:Home>ISO Standards>ISO 1207-2011 pdf free download

ISO 1207-2011 pdf free download

ISO 1207-2011 pdf free download.Slotted cheese head screws — Product grade A
Vis a métaux a tête cylindrique fendue — Grade A.
This ISO 1207 specifies the characteristics of slotted cheese head screws of product grade A and with threads from M1,6 to M10 inclusive.
If, in special cases, specifications other than those listed in this International Standard are required, they can be selected from existing International Standards, for example ISO 261. ISO 888, ISO 898-1. ISO 965-2. ISO 3506-1. ISO 4759-1.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (induding any amendments) applies.
ISO 225, Fasteners — Bolts, screws, studs and nuts — Symbols and descriptions of dimensions ISO 261, ISO general purpose metric screw threads — General plan
ISO 898-1, Mechanical properties of fasteners made of carbon steel and alloy steel— Part 1: Bolts, screws and studs with specified property classes — Coarse thread and tine pitch thread
ISO 965-2, ISO general purpose metric screw threads — Tolerances — Part 2: Limits of sizes for general purpose external and internal screw threads — Medium quality
ISO 965-3, ISO general purpose metric screw threads — Tolerances — Part 3: Deviations for constructional screw threads
ISO 3269. Fasteners — Acceptance inspection
ISO 3506-1. Mechanical properties of corrosion-resistant stainless steel fasteners — Part 1: Bolts, screws and
ISO 4042, Fasteners — Electroplated coatings
ISO 4753, Fasteners — Ends of parts with external ISO metric thread
ISO 4759-1, Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts — Product grades A. B and C
ISO 6157-1 • Fasteners — Surface discontinuities — Part 1: Bolts, screws and studs for general requirements
ISO 8839, Mechanical properties of fasteners — Bolts, screws, studs and nuts made of non-ferrous metals
ISO 8992, Fasteners — General requirements for bolts, screws, studs and nuts
ISO 10683, Fasteners — Non-electrolytically applied zinc flake coatings ISO 16048, Passivation of corrosion-resistant stainless-steel fasteners
3 Dimensions
See Figure 1 and Table 1.
The shank diameter is approximately equal to the pitch diameter or equal to the major thread diameter permissible.
The symbols and descriptions of dimensions are specified in ISO 225.ISO 1207-2011 pdf free download.

Download Information
Go To Download

All resources on this website are from the Internet. It is only for personal study and research. No one is allowed to use it for any commercial purpose. If you need, please buy the genuine standard. If there is any infringement of your copyright, please contact the webmaster in time, and I will correct it immediately.