- Hot search:
ISO 15-2011 pdf free download
ISO 15-2011 pdf free download.Rolling bearings — Radial bearings — Boundary dimensions, general plan
Roulements — Roulements radlaux — Dimensions d’encombrement, plan genéral.
This ISO 15 specifies preferred boundary dimensions for radial bearings of the diameter senes 7, 8, 9, 0, 1, 2. 3 and 4.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 464, Rolling bearings — Radial bearings with locating snap ring — Dimensions and tolerances
ISO 582, Rolling bearings — Chamfer dimensiOns — Maximum values
ISO 5593, Rolling bearings — Vocabulaiy
ISO 12043. Rolling bearings — Single-row cylindrical roller bearings — Chamfer dimensions for loose rib and non-nb sides
ISO 12044. Rolling bearings — Single-row angular contact ball bearings — Chamfer dimensions for outer ring non-thrust side
ISO 15241. Rolling bearings — Symbols for quantities
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 5593 apply.
4 Symbols
For the purposes of this document, the symbols given in ISO 15241 and the following apply.
The symbols shown in Figure 1 and given in Tables 1 to 8 denote nominal dimensions, unless specified otherwise.
B beanng width
D bearing outside diameter
d bearing bore diameter
r chamfer dimension
5 Boundary dimensions
Boundary dimensions for radial bearings of the diameter series 7, 8. 9, 0. 1, 2, 3 and 4 are given in Tables 1 to 8.
The chamfer dimensions given in Tables 1 to 8 do not always apply to:
— the groove side of bearing rings with snap ring groove: these are specified in ISO 464;
the loose rib and the non-nb sides of cylindrical roller bearing rings: the exceptions are specified in
ISO 12043;
the non-thrust side of angular contact bearing outer rings; these are specified in ISO 12044. Chamfer dimension, r, applies at the corners indicated in Figure 1 and is specified with rsmm in Tables 1 to 8.
The chamfer dimensions for inner rings of bearings with tapered bore may be smaller than those shown in Tables 1 to 8.
The corresponding largest single chamfer dimensions to the r3 , dimensions in Tables 1 to 8 are given in
ISO 582.ISO 15-2011 pdf free download.
All resources on this website are from the Internet. It is only for personal study and research. No one is allowed to use it for any commercial purpose. If you need, please buy the genuine standard. If there is any infringement of your copyright, please contact the webmaster in time, and I will correct it immediately.
- Maybe you like
- More
- Latest Updates
- ISO 287-2009 pdf free download
- ISO 527-5-2009 pdf free download
- ISO 659-2009 pdf free download
- ISO 660-2009 pdf free download
- ISO 712-2009 pdf free download
- ISO 725-2009 pdf free download
- ISO 730-2009 pdf free download
- ISO 927-2009 pdf free download
- ISO 2041-2009 pdf free download
- ISO 3040-2009 pdf free download
- ISO 3506-2-2009 pdf free download
- ISO 3506-3-2009 pdf free download