ISO 1832-2017 pdf free download

ISO 1832-2017 pdf free download.Indexable inserts for cutting tools — Designation
Plaquettes amovthles pour ourils coupuns — Designacion.
4 Explanation of designation code
For indexable inserts, the designation code comprises nine symbols for designating the dimensions and other characteristics; the first seven symbols (symbols ® to ®) shall be used in every designation. Symbols ® and ® may be used when necessary.
For tipped inserts in accordance with ISO 16462 and ISO 16463, the designation code comprises 12
s mbols for designating the dimensions and other characteristics; symbols to as well as (i and
12 shall be used in every designation. Symbols ®, ® and may be used when necessary. Symbols ©
and © shall be separated by a dash as shown in Clause 4. example 2.
In addition to the standardized designation for indexable inserts and tipped inserts, a supplementary symbol @ consisting of one or two characters may be added by the manufacturer for a better description of his/her product (for example, different chip breakers), provided this symbol is separated from the standardized designation by a dash and that it does not contain letters specific to references ®,®and.
No addition to or extension of the designations specified in this document shall be made without consultation with ISO/TC 29 and without its agreement. Rather than adding symbols not provided for in this system, it is preferable to add all necessary explanations in the form of detailed sketches or specifications to the designation in accordance with this document.
However, if the letter symbol XN is used in position 4 of the designation, it is allowed to use, in positions 5, 6 and 7. symbols representing values not appearing In this document, but which shall be described explicitly using the sketch or the detailed specifications given in £4.
The significance of the symbols constituting the designation code is as follows:
6 Optional symbols for indexable inserts
6.1 General
The compulsory designation for indexable inserts other than those specified in ISO 16462 and
ISO 16463 comprises the seven symbols given in Li. to 52. As stated in Clause 4. the symbols given in
62 and 63 may be used when necessary.
If only one symbol is needed (cutting edge condition or cutting direction), it shall occupy positIon 8. If both cutting edge condition and cutting direction are to be specified, the two symbols shall occupy positions 8 and 9, respectively.
Symbols given in 62 and 6 may also be used for designating tipped inserts in accordance with ISO 16462 and ISO 16463 where necessary.
62 Symbol for cutting edge condition — Reference ®
See Table 10.ISO 1832-2017 pdf free download.