ISO 464-2015 pdf free download

ISO 464-2015 pdf free download.Rolling bearings — Radial bearings with locating snap ring — Dimensions, geometrical product specifications (GPS) and tolerance values
Roulements — Roulements rc,diaux a segment d’arrêt — Dimensions, specification gCométrique des produits (GPS) et valeurs de tolerance.
This ISO 464 specifies the snap ring groove dimensions and tolerance values, chamfer dimensions on the snap ring groove side of the outer ring, and the snap ring dimensions and tolerance values for radial bearings in the dimension series 18 and 19 and the diameter series 0,2.3, and 4 (except dimension series 00. 82, and 83), as specified in ISO 15111.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 582, RoIling bearings — Chamfer dimensions — Maximum values
ISO 1101, Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run -out
ISO 5593. Rolling bearings — Vocabulary
ISO 14405-1, Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes
ISO 15241, Rolling bearings — Symbols for physical quantities
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 1101, ISO 5593 and ISO 14405-1 apply.
4 Symbols
See F to 3. and Table 1.
To express that the geometrical product specification (GPS) system is applied, the dimensional and geometrical characteristics shall be included in the technical product documentation (for example, on the drawing). The dimensional and geometrical specifications associated to them are described in Tab11.
A tolerance value associated to a characteristic is symbolized by t followed by the symbol of characteristic, for example tAas.
In this International Standard, the ISO default specification operator for size is in accordance with ISO 14405-1, i.e. the two-point size is valid.
In TablesZ to 5 Ad. A.2., ILl, and 82. the symbols U and L are used as follows:
— U = upper limit deviation
— L = lower limit deviation
An example of a real drawing indication is given in AnnexE.ISO 464-2015 pdf free download.