- Hot search：
ISO 502-2015 pdf free download
ISO 502-2015 pdf free download.Coal — Determination of caking power— Gray-King coke test
Charbon — Determination du pouvoir agglutinant — Essai Gray-King.
It is recommended that a dust mask is used while using the inert carbonaceous material which can contain undesirable trace elements from the original processing of this material.
5.1 Furnace, horizontal electric, 50 mm internal diameter and 300 mm long, with one end closed and the other carrying a plug of insulating material which is bored centrally with a hole 25 mm in diameter. The winding of the furnace shall be such that the middle 200 mm Is at a uniform temperature within ±5 °C at both 300 °C and 600 °C. Alternatively, the furnace may be constructed from an electrically-heated aluminium-bronze block, with one or several, bores of 25 mm diameter. The furnace shall be insulated and located in a cover of metal or other suitable material, and shall be equipped with a suitable thermocouple, lying above the retort tube when the latter is in position and with the junction at the centre of the furnace. An indicator shall be provided for showing the furnace temperature with an accuracy of ±5 °C. A suitable means of controlling the energy input shall also be provided to permit an increase in temperature at a rate of 5 °C/min. A multiple tube furnace to allow simultaneous determinations is convenient. The furnace may be of the fixed type or mounted on rails. Suitable furnaces are shown in figurel and Figure 3.
5.2 Retort tube (see Figure 4), a heat-resistant glass or transparent silica tube, 20 mm internal diameter and 300 mm long, closed at one end, with a side arm. 8 mm internal diameter and 50 mm tong, sealed in at a distance of about 20 mm from the open end. The tube shall be smooth and either of uniform bore or with a slight taper (19 mm to 21 mm) such that the open end is the larger.
5.3 DIstance rod, with a flat disk at one end to assist in the packing of the coal and to indicate the free end of the coal sample in the retort tube.
5.4 Receiver and outlet tube
A glass vessel of adequate size, suitably supported and attached to the side arm of the retort tube, fitted with an outlet tube leading to atmosphere or to a piece of small bore silica tubing at the end of which the gas leaving the receiver can be burned through Bunsen burner (in a fume cabinet) to ensure toxic fumes are burnt before venting to the atmosphere through the fume cabinet.
The receiver may conveniently be a U-tube which can be immersed in water.
The outlet shall be open to the atmosphere to prevent pressure build-up.
Fumes are toxic and it is recommended that the process is carried out in a fume cupboard.
The tar receiver should be cleared on a regular basis, by placing tar in a heat resistant crucible and burning off in a furnace.
WARNING — THE FUMES ARE TOXIC AND DUE CARE SHOULD HE EXERCISED IN THEIR DISPOSAL.ISO 502-2015 pdf free download.
All resources on this website are from the Internet. It is only for personal study and research. No one is allowed to use it for any commercial purpose. If you need, please buy the genuine standard. If there is any infringement of your copyright, please contact the webmaster in time, and I will correct it immediately.
- Maybe you like
- Latest Updates
- ISO 287-2009 pdf free download
- ISO 527-5-2009 pdf free download
- ISO 659-2009 pdf free download
- ISO 660-2009 pdf free download
- ISO 712-2009 pdf free download
- ISO 725-2009 pdf free download
- ISO 730-2009 pdf free download
- ISO 927-2009 pdf free download
- ISO 2041-2009 pdf free download
- ISO 3040-2009 pdf free download
- ISO 3506-2-2009 pdf free download
- ISO 3506-3-2009 pdf free download