ISO 8405-2013 pdf free download

ISO 8405-2013 pdf free download.Tools for moulding — Ejector sleeves with cylindrical head — Basic series for general purposes
Outillage de moulage — Ejecteurs tubulaires a tête cylindrique — Série de base pour usaqes généraux.
This ISO 8405 specifies the dimensions and tolerances, in millimetres, of ejector sleeves with cylindrical head which are used in compression and injection moulds and in die casting dies.
It also gives material guidelines and hardness requirements, and specifies the designation of ejector sleeves with cylindrical head.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 6751:2011, Tools for moulding — Ejector pins with cylindrical head
3 Dimensions
The dimensions of ejector sleeves with cylindrical head shall be in accordance with the indications of Figure 1 and Tahle.1.
5 Designation
Ejector sleeves with cylindrical head according to this International Standard shall be designated by the following:
a) “Ejector sleeve with cylindrical head”;
b) a reference to this International Standard (i.e. ISO 8405:2013);
c) the diameter, D1, in millimetres;
d) the length, L, in millimetres;
e) the material.
EXAMPLE An ejector sleeve with cylindrical head with diameter D1 = 2 mm, length L = 75 mm, and made of hot worked steel Is designated as follows:
Ejector sleeve with cylindrical head ISO 8405 – 2 – 75 – Hot worked steel.ISO 8405-2013 pdf free download.