ISO 9182-5-2013 pdf free download

ISO 9182-5-2013 pdf free download.Tools for pressing — Guide pillars — Part 5:Type D, end-locking pillars with flange
Outillage de presse — Colon nes de guidage — Partie 5: Type D, colonnes a retenue inférleure. démontables.
This part of Iso 9182 specifies the dimensions and tolerances, in millimetres, of guide pillars, type D, end-locking pillar with flange, intended for use in press tools.
It gives guidance on the materials and specifies the hardness and the designation of guide pillars which meet the requirements of this part of ISO 9182.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 6753-1:2005, Tools for pressing and moulding — Machined plates — Part 1: Machined plates for press tools
3 Dimensions
The dimensions of end-locking guide pillar with flange (type D) shall conform to the indications of Figure 1 and Table 1.
4 Material
The material Is left to the manufacturer’s discretion and the hardness shall be (62 ) HRC.
5 Designation
Guide pillars for press tools in accordance with this part of Iso 9182 shall be designated by
a) Guide pillar
b) a reference to this part of ISO 9182, i.e. ISO 9182-5;
c) its type;
d) its diameter, d1, in millimetres;
e) the bush length, 12, in millimetres;
1) the length, 1, in millimetres.
EXAMPLE A guide pillar, type D, of diameter d1 = 12 mm. length ‘2 = 12 mm. and a length I = 63 mm is designated as follows:
Guide pillar ISO 9182—5 — D – 12 x 12 x 63.ISO 9182-5-2013 pdf free download.