UL 62275-2016 pdf free download

UL 62275-2016 pdf free download.Cable Management Systems – Cable Ties for Electrical Installations.
9.7.1 As-received
The samples shall be fixed firmly to a rigid support. An appropriate cable tie shall be assembled to the fixing device and then to a steel or aluminium mandrel according to 5.9. Typical arrangements of the test assembly for fixing devices are shown in Figure 5. See 5.8.
NOTE where the tixèng dev.ce and cable tie are manulaclured as an integral product, the whole product will be the samp’e.
For a fixing device that is integrally moulded with a cable tie or supplied separately and classified according to 6.2.2, each sample shall be subjected to a tensile pull. The maximum force is measured. No individual value shall be less than the declared mechanical strength.
For a fixing device that is integrally moulded with a cable tie or supplied separately and classified according to 6.2.3, the samples shall be subjected to a tensile pull until the mechanical strength declared by the manufacturer is reached. This load is maintained for (60 ) s.
After the test. the fixing device or cable tie shall show no sign of disintegration nor shall there be any crack visible to normal or corrected vision. The support structure is not to be considered.
9.7.1DV Dl Modify 9.7.1 by replacing it in its entirety with the following:
9.7.1DV.1 A fixing device that is not provided with the means necessary to complete its assembly In or to a mounting surface shall be fixed firmly to a rigid support according to the manufacturers instructions. For a separately supplied fixing device, an appropriate cable tie shall be assembled to the fixing device and then to a non-split mandrel according to 5.9. For a fixing device that is integral to a cable tie, the Integral tie shall be installed on a non-split mandrel according to 5.9. Typical arrangements of the test assembly for such fixing devices are shown In Figures 5ADV and 5CDV. The mounting hardware used to attach the fixing device to the mounting surface shall not be tested.
9.7.1DV.2 A fixing device that Is provided with the means necessary to complete Its assembly in or to a mounting surface shall be assembled as intended to an appropriate surface. For a separately supplied fixing device, an appropriate cable tie shall be assembled to the fixing device and then to a non-split mandrel according to 5.9. For a fixing device that Is integral to a cable tie, the integral tie shall be Installed on a non-split mandrel according to 5.9. Typical arrangements of the test assembly for fixing devices are shown in Figure 5BDV. Where the fixing device and cable tie are manufactured as an integral product, the whole product shall be the sample. The loop tensile strength of the cable tie and the mechanical strength of the fixing device shall be evaluated according to
5.8.UL 62275-2016 pdf free download.